Flexi Hose Review – Should You Buy This Hose? - The pipe knows (2023)

FAQs

Are Flexi hoses any good? ›

The Flexi Hose was the most expensive hose we tested, but we rated it one step down because of its small cheap nozzle. However, it does have high-quality, solid brass fittings that didn't leak while watering the lawn. The Flexi Hose has four latex inner cores, which may need increased water pressure to work properly.

A good garden hose should last five to 10 years with proper care, but you'll need to replace that hose a whole lot sooner if you don't maintain it the right way.

Polytetrafluoroethylene (PTFE) hoses are non-reactive, durable, and flexible, making them the ideal option for a wide range of industrial applications.

One of the most serious drawbacks of flexible hose is that their thickness (0.26-mm) is not sufficient to withstand corrosion in cases where the hose is not completely chemically resistant to the media to which it will be exposed.

So why do they burst? The rubber tube inside flexi hoses expands under pressure and the stainless steel braid is designed to prevent further expansion. However, if the stainless steel fails and breaks, water pressure will cause the rubber lining to bulge out of the sleeve and rupture.

Any restriction to pipework will reduce the flow, the length of the restriction is immaterial, IT IS A RESTRICTION. Flexible pipes on mains applications may be OK due to higher pressures involved. Anything connected to a tank in the loft should not be restricted if possible.

The biggest problem with flexi hoses is damage prior to or during installation. Over tightening, over stretching and looseness can all cause the pipe to fail.

It is certainly OK to turn off the water at the end of a hose for short periods. If you leave it on this way for long periods you are stressing the hose which could lead to a ruptured hose when you are not around. This could lead to a waste of water or to water damage if the hose sprays on something.

Generally, a quality expandable hose is not as durable as standard garden hoses and won't withstand as much internal water pressure. If your spigot's water pressure is over 50 psi, consider attaching a flow reducer to keep the water from exerting too much pressure in the hose.

A hose width of five-eighths inch is generally most useful. It's a good combination of water flow and pressure without being too heavy. If hose weight is an issue for you, a half-inch hose may be best. They tend to be lighter weight but because of the smaller diameter they don't carry as much water.

What is best hose for water pressure? ›

Large (3/8”) hoses are designed for all professional models and some prosumer-grade gas pressure washers. These hoses can withstand serious water pressure up to 10,000 psi. Plus, they're thicker to allow greater water volume (more gallons-per-minute).

Does hose diameter affect water pressure? A Larger diameter hose helps maintain the current water pressure as there is less resistance to the natural flow. A smaller diameter restricts the water flow, and in turn reduces the water pressure, but it increases the velocity (speed) the water travels.

100% Satisfaction Guarantee • Lifetime Warranty • Free US Shipping & Returns Ships within 2 business days. This opens in a new window. Fighting a hose takes all of the joy out of gardening and car washing!

PEX pipes

The pipe is rigid enough to withstand pressures from the water supply and its highly flexible design means it can bend up to 90°angles. This makes it possible to weave the pipes throughout walls, ceilings, basements and tight spaces.

Flexible hoses are very versatile and significantly reduce the time it takes to hook-up hot and cold water pipe appliances, such as taps, dishwashers and water heaters.

Hoses can be stored outside as long as you make sure to drain all of the water from the hose. Hoses can be drained easily by running them over a tall place where gravity forces water to exit the hose. This ensures that the hose won't split when any residual water freezes.

Temporary repairs can be made by wrapping slightly damaged section of hose with vinyl electrical tape, but replacement of the hose will probably be necessary eventually.

You'll Hear Loud Hissing Sounds

A loud engine exhaust usually is one of the first indicators of a faulty flex pipe. Once a tube breaks, it may cause an exhaust leak which, in turn, contributes to the noisy hissing or tapping sounds emitting from the engine. This sound can become more pronounced during acceleration.

Like any other piece of metal, even though a flex pipe is made to flex for the life of the vehicle, flex pipes can fail over time due to continual flexing. While flex pipes can handle vibrations much better than other exhaust pipes, years of absorbing every bump and shake can make them crack.

Can you use a flexi hose on a toilet? ›

This connector hose is suitable for use with a wide range of toilets and taps making it a valuable addition to any bathroom space.

How can you determine if a flexible hose has been correctly or incorrectly installed? The lay line will be straight if the hose is properly installed.

I would say 1/4 turn is a good benchmark. If it doesn't feel snug at that point (or if you use plumber's grease on the nut and gasket like I do) give er a little extra love.

In fact, pipes should only be hand tight to help aid the flow of water throughout your home. The unique construction and configuration of pipes means they are made to be tightened just enough, making them super tight can actually prevent water from flowing properly.

If your expandable / pocket hose is leaking in the middle it's likely the inner flexible tube has a hole in it. But unlike a regular rubber hose, pocket hose cannot be patched up with a waterproof tape. You will need to do a little bit to work to get it fixed.

The best way to store an expandable hose is in a container or hose storage pot. They should be stored indoors, out of direct sunlight, or in a storage container with a lid. Stylish hose pots can be a great storage solution for these types of hoses.

Hoses should typically be replaced every four years. Because of the cost and extent of the damage that can be caused from a broken belt or burst hose, it is good to have a mechanic regularly check these things and to err on the side of caution.

The biggest issue with expandable garden hoses is that they are more prone to rips and tears than traditional garden hoses. This is why it is so important always to buy a high-quality expandable garden hose and take care of it properly.

Braided lines are stiffer than rubber lines and are more durable. Add the proper hose ends to the tubing if you buy a roll of it. You could also purchase braided hose to fit specific applications. Braided hose provides better heat dissipation and better flow, which is important when choosing performance car parts.

If you leave a garden hose outside for winter, it will be damaged in the spring. The extreme cold causes the internal lining to break. With a drained hose in your hand, carefully coil it into a three-foot diameter. Don't coil it into a tighter configuration, however.

Is a 3 4 or a 5 8 hose better? ›

If you compare both hoses, you will find that the overall discharge rate of a ¾ inch water hose is significantly higher than that of a ⅝ inch pipe. At a length of 25 feet, a ¾ inch water hose is capable of delivering up to 72 gallons of water every minute, which is nearly twice as compared to ¾ inches.

You may not have noticed, but hoses come with a pound per square inch, or PSI, rating. The average pressure for home faucets falls in the range of about 50 PSI, but it can be as high as 80. In some cases, regulators need to be installed to limit the PSI, and they will help prevent damage to your plants.

The 100-foot jetter hose is compatible with gas and electric pressure washers rated at 1000-3600 PSI.it is also very easy to use.

6,000 PSI and Above Pressure Washer Hoses

Pressure washer hoses in this category are meant for heavy-duty pressure washers rated at least 6,000 PSI. Pressure washers with this kind of output are typically only used in commercial applications because the high pressure can damage underlying surfaces.

PVC air hoses have a harder time in cold temperatures because it reduces their flexibility. A rubber hose keeps a stable flexibility level even in freezing temperatures, so does polyurethane air hoses and hybrid variants.

1/4-inch diameter hoses are the most commonly used for residential-use or consumer-grade pressure washers, both electric and gas-powered. The maximum psi that they can accommodate varies, so make sure to check your unit to see if it can handle your machine.

Yes and no. Larger pipes increase the water flow through the line, but if the water isn't up to that necessary flow, it won't increase your water pressure. Municipal water systems have impressive pressure, but that doesn't mean a larger line can help. Bigger lines do not always help things get faster o stronger.

Keeping on Top of Pressure Drop

Pressure drop from an air hose is unavoidable to a certain extent, but there are things you can do to minimise it: Run a shorter hose. The longer your airline, the greater pressure drop you'll notice.

Strain on your employer

Employers effectively take a gamble when they grant a flexible working request. For flexible arrangements to work there must be give and take on both sides. If not carefully managed, flexible working can lead to inefficiencies and a drop in quality and communication.

What are the positives and negatives of flexible working? ›

Stretching your body to become more supple and flexible offers many physical benefits. Such training allows for easier and deeper movements while building strength and stability. Stretching your muscles and joints also leads to greater range of motion, improved balance, and increased flexibility.

Generally, you should replace your flexible hoses every five years. However, it's a good idea to check them regularly. corrosion or rust spots on the braided section of pipe.

Unfortunately, they also present some disadvantages, the main one being the sensitivity to several failure mechanisms, which in many cases lead to premature withdrawal of the pipes, in other words, before the end of their previously designed service life.

Avoid using polyvinyl chloride (PVC) and chlorinated polyvinyl chloride (CPVC). These pipes contain the highest levels of chemicals of concern and they are typically installed using hazardous solvents.

Copper Pipes

Copper pipes remain popular among plumbers and homeowners alike because they are corrosion-resistant and best suited to protect the quality of the water. Copper pipes are able to handle high water pressure and are tolerant of both hot and cold water temperatures.

Generally, stainless steel flexible hoses will need replacing every 5-10 years. Before you find yourself in deep water, it's wise to check hoses regularly, preferably by a professional plumber.

Whether the hose is rigid or not, the forces acting on its walls don't move them, so no work is done on the hose - the pressure is not affected.

The primary advantage of flexible metal hoses is their flexibility. They can bend and twist without breaking, which makes them ideal for applications where rigid piping would not work. This flexibility also allows for easier installation in tight spaces and around obstacles.

Generally, you should replace your flexible hoses every five years. However, it's a good idea to check them regularly. corrosion or rust spots on the braided section of pipe. bulging areas on the pipe (it will look like a little black balloon).

Which brand water pipes is best? ›

Copper. Copper pipes are probably the most traditional plumbing pipe used due to their extensive duration and reliability. They provide superior corrosion resistance, great material to be used for hot and cold water, and it can be managed easily.

One of the main downsides to expandable hoses is that the outer hose is usually made from softer material than normal hoses and can therefore be prone to ripping. There's a more robust inner tube, but that, again, is more malleable than your usual hose, which can mean tears.

The kind of vibration, offset motion, motion, as well as necessary length to absorb them, are all the important things to take-into-account in determining the right flexible hose for an application.

Flexible hoses are recognised as having a higher risk of failure than a properly fitted metal pipe. An isolation valve fitted at the point of supply allows a flexible hose to be safely isolated in the event of leakage.

The key difference between hose and pipe is that hoses are more flexible and are made of materials like rubber and plastic, while pipes are more rigid and are made of materials like metal and PVC. Hose and pipe are lengthy hollow cylinders we use to transport liquids.